poking coal boiler clinkering

  • what causes clinkers in coal fired boilers? | hunker

    What Causes Clinkers in Coal Fired Boilers? | Hunker

    Clinkers have been a recurring problem in all coal-fired boilers for as long as humans have operated coal boilers. Clinkers occur in small stoves used for heating a home and in giant commercial/industrial boilers. Clinkers, also known as slag, consist of the noncombustible elements and minerals found in coal that melt and fuse together as lumpy ashes from coal …

    View More
  • top 10 reasons behind clinker formation in boiler …


    Jul 20, 2019· Summary: major cause or clinker formation inside the boiler furnace as well as thermopack heater is overfeeding which causes the increase the bed material or coal ash temperature up to the fusion point which cause the clinker formation inside the boiler furnace so that during operation it must be observed that if the furnace temperature goes above the high limits reduced the coal feeding and also rectified the points which cause the furnace …

    View More
  • poking coal boiler clinkering – cfbc boiler manufacturer

    poking coal boiler clinkering – CFBC Boiler Manufacturer

    2014-3-3 · step:in addition to boiler firing, coal is added to flaming wood with regularly start and shut of fan to provide clinkering box when boiler is ignited and steam … Stoker Coal Boiler: Since I have been poking this clinker for a few days now I have noticed that it is harder, The BairMatic – Van Wert Project

    View More
  • what causes clinkers in coal fired boilers?

    What Causes Clinkers in Coal Fired Boilers?

    What Causes Clinkers in Coal Fired Boilers? Clinkers, or slag, are made up of elements and minerals found in coal which are non-combustible. When burnt, they melt and fuse together, forming lumpy ashes. For as long as we have operated coal boilers, clinkers have been a recurring problem, occurring in small stoves used for heating a home right up to giant commercial/industrial boilers.

    View More
  • avoid clinker formation in boiler using good quality coal

    Avoid Clinker Formation in Boiler using good quality coal

    Clinker Formation in Boiler of Thermal Power Station is due to high Ash Content which have low fusion temperature below 1500 degree centrigrade and Minerals present in it.Due to poor Quality of Coal ash got fused and mineral content stick into Water Wall which is very difficult to remove often requires removal by pneumatic machines.This Clinker deposition may be stopped to some extent if sufficient water is sprayed into hopper and regular poking …

    View More
  • typical causes of slagging and fouling problems in boilers

    Typical Causes of Slagging and Fouling Problems in Boilers

    Jun 01, 2015· Boiler slagging and fouling, and the resulting frequent operation of sootblowers, are some of the major operations and maintenance factors …

    View More
  • how to adjust to limit clinkers? | stoker coal boilers

    How to Adjust to Limit Clinkers? | Stoker Coal Boilers

    Jan 13, 2017· Clinkers result from coal with a low ash-fusion temperature.Clinkers are when the ash "melts".Some veins will not clinker until close to 3500 degrees.When initial deformation of the ash is around 2500 or less,you will likely have clinkers.So,trying to burn your coal at a lower temp is one thing to do,by cutting back on air as long as you are ok with the heat output.If this doesn't help your situation,you have low fusion coal,and might need to blend a higher fusion coal …

    View More
  • guide to clean and efficient operation of coal-stoker

    Guide To Clean And Efficient Operation Of Coal-Stoker

    May 1981 EPA-600/8-81-016 A GUIDE TO CLEAN AND EFFICIENT OPERATION OF COAL-STOKER-FIRED BOILERS Guidelines intended for use: - by personnel responsible for boiler operation to perform an efficiency and emissions tune-up - by plant engineers to initiate maintenance and efficiency monitoring practices - as a supplement to manufacturer's service instructions American Boiler Manufacturers

    View More
  • slagging properties of coals and allowance for them in the

    Slagging properties of coals and allowance for them in the

    Abstract. It is shown that out-of-design coal should be used only after computational analysis of slagging of the boiler. The use of ash fusibility as a criterion for the analysis should be avoided because this property does not reflect the slagging properties of coal to an acceptable degree.

    View More
  • what are reasons for clinkers being formed in coal based

    What are reasons for clinkers being formed in coal based

    Nov 14, 2017· The coal which we use has the carbon which changes to Carbondioxide on burning and gives heat. The rest of the fuel material after the burning is ash. The ash is a solid material. But when the temperature inside the furnace rises above 900degree Celsius, the ash becomes sticky and joins to form lumps with the fuel coal. This is the clinker.

    View More
  • 1.3 properties of coal - researchgate

    1.3 Properties of Coal - ResearchGate

    Affects clinkering and slagging tendencies Preparation of coal prior to feeding into the boiler is an important step for achieving good combustion. Large and irregular lumps of coal may cause

    View More
  • clinker removal from coal fired boilers sun chemical.mpg

    clinker removal from coal fired boilers sun chemical.MPG

    clinkar removal and reduce maintenace using sun chemical co.ltd coal additive www.sun-chemical.jp

    View More
  • coal properties and its influence on boiler pankaj ekbote

    Coal Properties and its influence on Boiler Pankaj Ekbote

    Properties of Coal • Coal properties are evaluated by different methods. • The most commonly used methods are Proximate and Ultimate analysis of the coal. • Proximate analysis gives the Moisture, Ash and Volatile matter, while the Fixed Carbon is found by difference. • Ultimate Analysis gives the elemental composition of the coal. • Other methods like Macarel analysis is also used

    View More
  • coal | igesolutions2

    coal | Igesolutions2

    Black smoke, clinkering, emissions, or combustion issues? We work closely with you to make sure you are getting the optimum results from your boiler. Please also check out our locally manufactured ECO Additive to get a cleaner, more efficient burn .

    View More
  • report on unit-5 clinker formation | coal | furnace | free

    Report on Unit-5 Clinker Formation | Coal | Furnace | Free

    At 10:40 Hrs Load kept at 300MW, simultaneously Left hand side clinker removal was in progress by poking and jetting. Unloading of bottom ash on ground was continued. Total coal flow reduced from 340 to 235 T/Hr. O2% maintained at more than 5.5%. Continuous clinkering observed inspite of poking …

    View More
  • efficiency of steam boiler systems | steam boilers in india

    Efficiency Of Steam Boiler Systems | Steam Boilers In India

    Clinkering can be reduced by using good quality fuel. The fuel quantity needs to be monitored. In coal-fired boiler, water is used to flush molten slag and ash from the hopper to prevent deposit. Slagging and fouling refer to ash deposits in the convection zone. It is caused because of secondary combustion in the upper furnace zone. It is formed when the furnace temperature is very high or the furnace is undersized.

    View More
  • coal - slideshare

    Coal - SlideShare

    Jul 24, 2013· COAL BLENDING Keeping in mind the design features & others, we can operate Indian boilers with blended coal i.e. a mixture of Imported coal & Indian coal, limited to the blend ratio, which is most nearest to their design. Inspite of best of blending each particle of coal …

    View More
  • 1.2 anthracite coal combustion

    1.2 Anthracite Coal Combustion

    Due to its low volatile matter content and non-clinkering characteristics, anthracite coal is primarily used in medium-sized industrial and institutional stoker boilers equipped with stationary or traveling grates. Anthracite coal is not used in spreader stokers because of its low volatile matter content and relatively high ignition temperature.

    View More
  • stoker firing | combustion | coal

    Stoker Firing | Combustion | Coal

    UNDERFEED STOKERS: The coal is fed into the grate below the point of air admissions, and suitable for non-clinkering, high volatile coals. TRAVELING-GRATE STOKER BOILER Coal is burnt on moving steel grate Coal gate controls coal feeding rate Uniform coal size for complete combustion CHAIN AND TRAVELLING GRATE STOKER

    View More
  • (pdf) continuous coke production - researchgate

    (PDF) Continuous coke production - ResearchGate

    A critical review reveals extensive experimental data on the continuous production of nonmetallurgical coke. In view of the large reserves of poorly clinkering coal in Ukraine and the need to

    View More
  • understanding the business of coal - ash fusion

    Understanding the Business of Coal - Ash Fusion

    Jul 24, 2017· Coal Slags and Ash Fusion Temperatures. The Ash Fusion Temperature, AFT, test became popular in the 1920’s as a way to judge clinkering on the grate of a stoker fired boiler.

    View More
  • cofiring biomass in a coal-fired boiler - bright hub

    Cofiring Biomass in a Coal-fired Boiler - Bright Hub

    Cofiring with coal ensures continuous operation of the boiler and ensures a return on investment. In most of the processes, biomass can provide only the partial energy requirement. Co-firing is required to meet the full energy requirement of the process.

    View More
  • amazon: firing the steam locomotive ebook: the reading

    Amazon: Firing the Steam Locomotive eBook: The Reading

    Aug 12, 2015· Firing the Steam Locomotive - Kindle edition by The Reading Company. Download it once and read it on your Kindle device, PC, phones or tablets. Use features like bookmarks, note taking and highlighting while reading Firing the Steam Locomotive.

    View More
  • given the high ash content of indian coal, how important

    Given the high ash content of Indian coal, how important

    1 day ago· Ash causes clinkering and slagging problems in boiler. Once the coal has been mined, it is usually processed to separate the inorganic, ash-forming components and to produce appropriately sized particles. The degree of preparation depends on the intended use of the coal, which is decided by coal analysis. Coal analysis/testing are the most

    View More


If you want to learn about our products , please call or write mail consultation.